Heating the floor in a room is not a modern concept as the Romans had this technology two thousand years ago. However, it is a concept which is seeing a resurgence in popularity, especially in small rooms such as bathrooms. With one of the most popular systems to heat the floor being electric, it is a common question as to whether it is safe to have this in a room that gets wet such as a bathroom. The short answer is yes!
How Does An Electric System Work?
An underfloor heating works by placing a series of wires on a mat creating a heating mat. These mats are then installed on the base floor level, and the floor goes on top. The systems vary in wattage between 100W and 200W, and the wattage your room will require will depend on a few different factors. It is essential to consider these factors as ignoring them could leave your room too hot or too cold.
What You Need To Consider
The first factor that you will need to consider is what the floor surface underneath that you will place the heating mats on top of is like? Ideally, the mats will be placed on top of a layer of insulation to help ensure the heat travels upwards. You will also need to consider how much insulation the room already has and if it is well insulated, you will require lower wattage mats. You will also need to look at the shape as well as the size of the room to work out how many mats you will need t heat the room. The last consideration is what the floor surface on top is going to be? If you are using brick, stone, or even a thick tile, you may require a higher wattage heating mat than if you used a wooden floor.
Installing The Heating System
The metal wires are all connected and sensors are also installed. The heating system is then connected to the mains supply and thermostat control unit. The sensors will help to regulate the temperature and stop the room from getting too hot. When you install a new system, it may take a bit of adjusting to get the temperature just how you want it, so do not be afraid to play with the settings.
Connected To Your Homes Circuit Breaker
As you will be using the mains supply to power your underfloor heating, it means that the system is also going to be protected by your circuit breaker. The heating maps will usually be covered in a thin layer of a concrete screed, and then the floor material you are using will be placed on top of this. With the electric cables being enclosed in a thin layer of the concrete screed, it gives them sufficient protection from water to ensure that the wires are kept dry. Electric underfloor heating is more popular than a water-based system, as they are much easier to install. You can get lots of excellent information on various websites on electric underfloor heating that gives you a detailed look at this type of heating system.